Warranty

PACK-ALL 2-YEAR WARRANTY

If any warranted part of your AlliancePackaging1 shrink system fails within the Two (2) Year Warranty* period due to a manufacturing defect, AlliancePackaging1 will furnish and ship the required replacement part (standard ground delivery) without charge. Warranted parts replaced must be returned to AlliancePackaging1 with shipping charges prepaid.


Components covered by the AlliancePackaging1  2-Year warranty* are as follows:
  • Bearings
  • Blower Motors
  • Circuit Boards
  • Electromagnets
  • Gearmotors
  • Heater Calrods
  • Idler Rollers
  • Lift Cylinders
  • Lift Table Components
  • Switches
  • Temperature Controllers
  • Timers
  • Thermocouples
  • Thermostats
  • Transformers
  • Tunnel Conveyor Drive Motors

Components not included are as follows:
  • Belts
  • Casters
  • Hardware & Fuses
  • Nichrome Seal Wire
  • Sheet Metal
  • Silicone Seal Pads
  • Teflon Curtains
  • Teflon Tape
  • Transite Insulator Strips

Diagnostic and labor charges for removal and installation of any defective component is the sole responsibility of the Purchaser or Distributor.

AlliancePackaging1’s responsibility is limited solely to the components listed as warranted in this document. This warranty does not cover damage by accident, abuse, misuse, installation in abnormal conditions of moisture, dirt or temperature, corrosive material(s), misapplication, or improper installation. Negligence in installation, use, or failure to follow the manufacturer’s recommended maintenance procedures will nullify the warranty. This warranty extends to the Purchaser for two (2) years* and becomes valid upon receipt at AlliancePackaging1 of the completed warranty card (sent with each machine), which must be returned within two (2) weeks of shipment.

Shipping damages must be identified at the time of delivery. Any observed damage must be noted on the bill of lading and, if possible, photographed and followed by a claim made to the freight carrier by the Purchaser. If the shipment is refused due to excessive damage, the Distributor must be notified and the shipment returned to the point of origin.

This warranty is void if any modification is made to the equipment, including use of any seal wires other than those that have been manufactured by Pack-All for use in the machine. Installation and training must be properly completed by authorized personnel. Installing wires made from a spool will require tools for installation and can cause component damage to the seal head assembly and could cause personal injury, voiding the warranty coverage on the system. Equipment operation is to comply with all applicable safety standards and is the sole responsibility of the Purchaser.

*NOTE: An optional third year of warranty is available at the time of purchase.